$141.02 – $575.56
SPECIFICATIONS:
Feature
Easy to use:
This product is a semi-flexible solar panelthat can be bent up to 30 degrees. It is suitable for mounted on an irregular smooth surfaces such as RV roofs, boats, tents, Yacht, vaulted roofs, etc.
High efficiency, Light weight:
Only 2.5mm thick, weight 2.02kg, easy to hang, disassemble and carry.
Easy to install:
Metal holes in the four corners of the product for fixing screws and mounting. Each solar panel has been tested several times.
The junction box in front of the solar panel has a Schottky diode built in to prevent reverse current.
Packing List
500W solar panel kit packing listing:
5* 100W flexible solar panel
1*5 in 1 PV parallel adapter
1* 12V/24v 50A solar charge controller
1* 3 meters cable with PV connector
1* 1 meter cable with Alligator clip
300W solar panel kit packing listing:
3* 100W flexible solar panel
1*3 in 1 PV parallel adapter
1* 12V/24V 30A solar charge controller
1* 3 meters cable with PV connector
1* 1 meter cable with Alligator clip
200W solar panel kit packing listing:
2* 100W flexible solar panel
1*2 in 1 PV parallel adapter
1* 12V/24V 20A solar charge controller
1* 3 meters cable with PV connector
1* 1 meter cable with Alligator clip
100W solar panel kit packing listing:
1* 100W flexible solar panel
1* 12V/24V 10A solar charge controller
1* 3 meters cable with PV connector
1* 1 meter cable with Alligator clip
Specification
Maximum Power(Pmax): 100W
Maximum Power Voltage(Vmp): 16.00V
Maximum Power Current (Imp): 6.25A
Open-Circuit Voltage (Voc): 19.2V
Short-Circuit Current (Isc): 6.68A
Maximum System Voltage: DC1000V
Weight: 1.91KG
Dimensions: 1050*530*2.5mm
Product Detail
solar panel kit/system Connection Diagram
Connecting your panels in series increases the voltage level and controllers accept higher voltage input.Wiring panels in parallel increase current,does not increase voltage.
1.First wiring,connect the controller to the battery.
First connect cable with alligator clips to controller by screwdriver.Then connect alligator clips(black ) to the negative pole of the battery, next connect alligator clips (red) to the positive pole of the battery,pay attention to the positive and negative poles.After correct connection, the controller will display the voltage parameters of battery.
2.Second wiring, connect the flexible solar panels to the controller.
First connect extend cable to the controller by screwdriver.Then connect connect parallel adapter to the solar panel.If there is only one panel, please ignore this step.Next connect parallel adapter to extend cable.taking care when connecting & disconnecting the connector to avoid damage.After right connection,the controller will display the solar panel is charging the battery.
3. The third step is to connect the DC load to the controller
4. Forth step, connect the invertor to the battery for AC output
